SimplerCloud Pte Ltd

Note: This article outlines how you can configure your Windows 10 workstation (running Windows 10 operating system) to connect to your VPN on your VPC. If you are using Windows 7 operating system, please refer to this article instead.

===

To configure your Windows 10 workstation to connect to the VPN on your VPC, you need to take note of the information that you have gathered during the VPN setup:

• IP address of the VPN
• IPsec preshared key
• Username
• Password

Note that you can use Windows' built-in VPN client for this purpose. Below information is based on a Windows 10 workstation. The steps might be slightly different on different version of Windows.

On your Windows 10 workstation, go to Control Panel, then select Network and Sharing center. Click "Setup a new connection or network".

In the next dialog, select "Connect to a workplace - Set up a dial-up or VPN connection to your workplace"

 

In the next dialog, select "No, create a new connection".

In the next dialog, select "Use my Internet Connection (VPN)".

In the next dialog, enter the public IP address of your VPN under "Internet address", and give the connection a name under "Destination name". Please check the option: "Remember my credentials".

Also, please ensure that this option is being checked: "Allow other people to use this connection" to allow other users within your workstation to also use the VPN connection. This setting is required if you need to establish this VPN connection to join a remote Active Directory (AD) domain on your VPC, and you need to use the VPN connection to log in to the domain.

Click "Create".

 

You will see that the VPN connection is created. Go back to the Control Panel > Network and Sharing Center and click on "Change adapter settings" / "Network Connections" to see the new connection. The connection is not active yet, still in "Disconnected" state. Right-click the new connection and select Properties.

In the Properties dialog, select the "Security" tab. In "Type of VPN" option, select "Layer 2 Tunneling Protocol with IPsec (L2TP/IPsec).

Select the "Allow these protocols" button and ensure that these two options are being checked:
- Challenge Handshake Authentication Protocol (CHAP)
- Microsoft CHAP Version 2 (MS-CHAP v2)

Go back to the Type of VPN option on the top and click on "Advanced settings".

Under Advanced Properties, select "Use preshared key for authentication". Key in the IPsec preshared key that you obtain when setting up the VPN, and then click "OK".

Back to the VPN Properties, go to "Networking" tab, select Internet Protocol version 4 (TCP/IPv4) and then click Properties.

Under TCP/IPv4 Properties, click on Advanced.

Under Advanced TCP/IP Settings, please ensure that "Use default gateway on remote network" is un-checked. This is to ensure that you can still access the Internet using your own Internet connection while connected to your VPC network through the VPN. Click OK.

The connection is ready for activation. Go back to Control Panel -> Network Connections and double-click the created connection. Click "Connect".

Key in the VPN username and password, and then click "OK".